Ruler doesn’t match page size (Word 2002)

Topic

New Reply

Very strange. Could it be the “unprintable area” for the current printer driver? Does it work better if you change printers?

Reply | Quote

Replies

I don’t think its printer related because all our other documents work absolutely correctly and this problem is repeatable for this file, on two different machines for two different users.
I’ll give it a go though when I get back to work as, thinking about it, we’re both pointing at the same network printer
I think I’ll also play with changing the paper size too – it can’t hurt

Reply | Quote

Can you try this? From the reviewing toolbar, click Show, Options, turn on balloons and set the margin to 0 then turn balloons off. Does this help?

Reply | Quote

Can you try this? From the reviewing toolbar, click Show, Options, turn on balloons and set the margin to 0 then turn balloons off. Does this help?

Reply | Quote

I don’t think its printer related because all our other documents work absolutely correctly and this problem is repeatable for this file, on two different machines for two different users.
I’ll give it a go though when I get back to work as, thinking about it, we’re both pointing at the same network printer
I think I’ll also play with changing the paper size too – it can’t hurt

Reply | Quote

Refer to the attached diagram. The horizontal ruler does not extend to the page width.
I’ve tried most of the tricks I know such as writing RTF, removing section breaks, cutting document to new document and still it appears short.

Normally, I expect the ruler to start at the left edge of the page as grey, become white at the left margin, become grey again at the right margin and extend to the edge of the page at the right.
This one seems to stop an inch or so short and I have no idea at all

Reply | Quote

I note from your Reviewing toolbar that you have markup showing. Could this simply be the space taken up by those balloons?

StuartR

Reply | Quote

This is a great theory! Normally, once all the changes are accepted the extra white space disappears, but maybe there is one lurking somewhere in the document.

Reply | Quote

This is a great theory! Normally, once all the changes are accepted the extra white space disappears, but maybe there is one lurking somewhere in the document.

Reply | Quote

Stuart – that was the clue I needed. Revisions were not turned on – but – deep in the document lurked a single comment.

to everyone for their help – once again I really appreciate the expertise and willingness to help

Reply | Quote

Stuart – that was the clue I needed. Revisions were not turned on – but – deep in the document lurked a single comment.

to everyone for their help – once again I really appreciate the expertise and willingness to help

Reply | Quote

I note from your Reviewing toolbar that you have markup showing. Could this simply be the space taken up by those balloons?

StuartR

Reply | Quote

Refer to the attached diagram. The horizontal ruler does not extend to the page width.
I’ve tried most of the tricks I know such as writing RTF, removing section breaks, cutting document to new document and still it appears short.

Normally, I expect the ruler to start at the left edge of the page as grey, become white at the left margin, become grey again at the right margin and extend to the edge of the page at the right.
This one seems to stop an inch or so short and I have no idea at all

Reply | Quote